Search models, users, collections, and posts
Raspberry Pi 5 Case
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
4.3 h
2 plates
Open in Bambu Studio
Boost
14
39
4
5
102
42
Released
Description
There are two variants of the bottom part:
- The first one uses M2.5 screws and hex nuts to secure the RaspberryPi to the bottom part. This variant is for use with a hat with studs or with with 6mm length screws.
- The second variant is held in place small studs in the printed part.
No supports should be needed for either part/variant.
Print in ABS or PETG.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)