The curious discards from the Bambu 3D printer, left unattended, will litter your desk or floor. Here is yet another "poop chute" to divert the filament effluent into an adjacent receptacle.

My design consists of two parts, a chute and a bin or "poop tray". The chute catches the filament waste and diverts it into an easier to get to small bin. The design aims to be minimal in print material, yet functional.

The chute secures to the back of the Bambu printer via a 3mm x 7mm self-tapping screw. The screw should be enough to retain the chute in position. Otherwise, double sided tape can assist. The bin comes in two sizes (50 and 100mm widths) and sits freely at the base of the chute and captures the waste.

With regards to a replacement screw, here's a couple of suggestions from my followers:
   1.  If you got your printer with the AMS, the screw that held it to the print bed is the perfect size to hold this in place.
   2.  The screws included with your Bambu printer to make up the scraper fit nicely, too.

My print is made in 1.75mm Bambu PLA Green filament, with 0.24mm layer height and 15% infill on a Bambu Lab X1 Carbon printer. Print supports are not required.

I hope you can find this print useful, too.

UPDATE
12/12/2023 Added a 100mm wide poop chute bin.