Magnetized Bambu Poop Chute for X1C, X1, P1P
Remixed by
Copyright Claim
Magnetized Bambu Poop Chute for X1C, X1, P1P
Remixed by
Boost
39
94
30
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
39
94
30
1
187
118
Released
Description
Model
This chute is inspired by the model of adriangarside. It's designed to redirect this excess filament to the side of the printer
Design and attachement:
There are some smooth geometries on the inside for the poop to slide down.
It's slightly larger then the X1C Printer (see pictures) and the thickness the chute is 2mm.
I added 4 holes to glue in magnetic holders. Size of the magnets are <5mm in diameter. The depth of the magnet holes are 1,3mm.
Personally I use 1mm thick magnets, so they are underneath the contact surface and won't scratch the printers shell.
It uses 30,77g of filament and takes about 1h17min to print.
Comment & Rating (30)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
small and simple. cannot hold to p1s but i think thats the problem of my magnets
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
too tiny path for poop. keeps getting stuck
The designer has replied
0
Reply
not once I had this issue...
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice design but too heavy for four magnets. During printing it slides down the printer.
The designer has replied
0
Reply
thanks for your feedback, maybe your magnets are too weak. Mine is holding fine even with three magnets...
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
s'imprime très bien et fonctionne aussi bien
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
magnets fit perfect
0
Reply
Hello, I like the idea of using smaller magnets to prevent scratching. Do you have a link to the ones you used?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
beautiful
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Der Durchgang müsste ein wenig breiter sein. Die Abfälle haben sich bei mir ein wenig verklemmt und sind nicht herunter gerutscht. Ich habe es dann breiter Sklaiert und nun ist es perfekt! Danke für das Model!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out great. Magnets of that size were a bit harder to find than I thought it would be.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld