Bambulab X1C/P1S Rear Fan Bentobox Hepa Filter Remixed by xPitax

Remixed by

xPitax

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1 h

1 plate

5.0(21)

0.2mm layer, 2 walls, 100% infill

Designer

14 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

167

170

Released

Description

I made an exhaust fan hepa filter holder for the bambulab printer that uses the same filter typer as the bento box air filter.

I bought the filter in a 10x pack and wanted to use the same filter also for the rear exhaust.

The holder is kept in place from 6 magnet 5x2mm.

I made also a file for TPU gasket, if you want to use the gasket i suggest to use the “gasket” model that have a bit less magnet dept to compensate gasket thickness.

For the holder I printed in PLA 0.20 layer, ironing 20% top surface for better adherence, no support needed.

For gasket printed in TPU 0.20mm layer 100% infill.

Comment & Rating (24)

@chilluniverse

Print Profile

0.2mm layer, 2 walls, 15% infill

Very well designed and easy to print!

@Chry113

Print Profile

0.2mm layer, 2 walls, 15% infill

Misure corrette

@user_1113120956

고마워요 잘사용 하겠습니다. ㅡㅡb Good

@ReturntoSender7

Print Profile

0.2mm layer, 2 walls, 15% infill

A great addition to the bento box. I only had 4mm magnets but a couple of dabs of glue and all good

@Killdozer666

Print Profile

0.2mm layer, 2 walls, 15% infill

exactly what I needed. great remix to the original. great aesthetics. I modified to fit the 6x2.5mm magnets I had on hand.

@UmbrellaCorp

Print Profile

0.2mm layer, 2 walls, 15% infill

Works finde printed with petg

(Edited)

@roberto.ardizzo

Print Profile

0.2mm layer, 2 walls, 15% infill

profilo esatto!

@hew_exso

Print Profile

0.2mm layer, 2 walls, 15% infill

good, fit with 80x40 hepa filter

(Edited)

@loose450

Print Profile

0.2mm layer, 2 walls, 15% infill

Great design. Simple and effective. Prints wonderful. I printed with .02 nozzle @ .10 layer and it looks like a factory part. Thanks!

@Rockygo46

Hi, thanks for sharing, but did you also upload this project to be able to insert the gasket? I also don't see the one to create the TPU gasket in your uploads. Thank you!