Bambu Reusable Spool Weight Holder
Copyright Claim
Bambu Reusable Spool Weight Holder
Boost
33
71
27
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.2 h
1 plate
Boost
33
71
27
0
179
157
Released
Description
Simple weight holder for Bambu reusable spools. I have a old coffee can full of 6-32 (M3 comparable size) nuts that I use as ballast. I designed this so it prints fast, in my case even with multicolor it prints in 1hr and 14m. Hope it can work for you as well…
Comment & Rating (27)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
I printed in abs and failed befor 10 minutes to finish
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I made also some smaller ones for e.g. Extrudr spools
0
Reply
Very nice part.
In addition I made a holder for batteries as a weight.
Since I don't want any moving parts as spool weights, this holder was designed to hold up to six AA batteries and press them against the housing wall without moving.
It´s a very quick print:
https://makerworld.com/en/models/122146#profileId-131607
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
très bien conçu.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
perfect for using sunlu spools on ams lite
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Great design!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed great! Cap screws on perfectly!
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
No Problems, works fine... thx
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Easy to print, works great.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Nice one!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld