Search models, users, collections, and posts
NFC Maker Chip Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
30
79
1
0
43
15
Released
Description
To go along with the NFC Maker Chip I created, I wanted a holder for them to keep on my table at Craft Show and Events.
Chip Model can be found here.
Simple model. No Supports needed. Flat surface to be able to add your own branding. Spot on the bottom to place the rubber pieces on the bottom to keep it from sliding on the table. Those rubber pieces can be found here.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)