NFC Maker Chip.
I created this model to hand out at an upcoming show I will be attending. Added a NFC chip so that the person I hand this to can scan it and be sent directly to my Linkt.ee with all my information. Left chip blank so that you can add your own logo or writing.
For this model I used NFC Stickers. Paused the print at Layer 11 and added the chip. I would put a drop of super glue on the non-sticker side. I would leave the sticker side up so that the sticky part was used for the filament had something to stick to when bridging over it.
I also made a holder for them to sit on the table that can be found here.
Comment & Rating (0)