A print-in-place keytag to organize all your belongings. Whether you want to organize your different keys to hang them up nicely on the wall or if you need to label your equipment when traveling. This unique design with its living hinge allows you to print the keytag in place without any supports or post processing required. It is printed flat on the print bed in its unfolded state so you can make use of your different print plate textures. It closes with a nice press fit.
If need to open and close the keytag multiple times make sure to use PETG so the hinges are more flexible in comparison to PLA.
Bambulab PETG Basic Red
Bambulab PETG Basic White
0.2mm layer height
no supports
4 walls
4 bottom shell layers
5 top shell layers
infil direction 0°
wall generator: arachne
transitioning threshold angle: 30°
Make sure that the infil direction starts at 0° so you have filament going horizontally from the left to the right side for maximum strength on the living hinge connecting the two halves.
Bottom view:
Key tag
Width 54mm
Height 22mm
Label
Width 34mm
Height 14mm
Make sure you have dried your PETG proiperly and use a clean build plate.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (34)