Key Tag | No Hinge

An alternative version of my print-in-place keytag but without the living hinge. So you can print it in PLA without any concerns and do not have to use PETG. The keytag consists of 3 separate parts that snap together and sandwich the included nametage in between. It is printed flat on the print bed so you can make use of your different print plate textures. It closes with a nice press fit. It shouldn't open even when dropped from normal standing height but if you want to be save just add a little drop of glue before assembly.

To change the text label simply edit the preset text on the left and don't forget to right-click on the text object in the left and center it again after you did some changes. Or you can skip that object and use a paper tag instead (required thickness 0.6mm).

Text settings from the example

Arial Bold

6mm

0.4mm thickness

0.0mm embedded depth

Print Settings

0.2mm layer height

no supports

3 walls

4 bottom shell layers

5 top shell layers

wall generator: arachne

transitioning threshold angle: 30°

Assembly

Dimensions

Lenght 54mm

Width 22mm

Height 3.5mm

Keychain Holes: 5mm

Note
Make sure you have dried your filament properly and use a clean build plate.

Optional

Once you tested the print you can duplicate the objects and print multiple ones at the same time. I still recommend printing each pair by object and not by layer. Please don't upload extra print profiles just for that.

Happy Printing!

You may also like:

Keytag with living hinge from PETG

https://makerworld.com/en/models/699200-key-tag-print-in-place#profileId-628453

Keytag with normal filament hinge

https://makerworld.com/en/models/2003406-key-tag-with-hinge#profileId-2157355