A 3D printed toolbox is designed with the goal of achieving tool freedom, and it can be used directly after printing without assembly.

The box joints are designed using snap-fit connections.

It is recommended to print with a layer height of 0.2.

Please set the support angle to only be effective for overhanging parts that exceed 80 degrees.
Please set the support angle to only be effective for overhanging parts that exceed 80 degrees.
Please set the support angle to only be effective for overhanging parts that exceed 80 degrees.

Due to the structure of the model, failure to use support or using too much support may cause printing to fail. Therefore, the support angle should only be effective for overhanging parts that exceed 80 degrees (using CURA slicing software).

This model is for personal use only.
It can be used for video shooting (please indicate the source of the model in the video).
Commercial use and resale are prohibited.