[Update in comment below using Bambu filament] It's a very cool model, though I've been having trouble getting it to stay together. The joint that finishes last when printing doesn't close all the way, leaving an opening for the connector ball to slide out of. The attached image compares that top most join with the bottom joint on the same side. I'm new to 3D printing an am using an A1 Mini, so I started with that profile. Then I switched to the updated strength version (no supports). The best results I've had so far are using variable layer height with 0.16 as the default and changing seam position to back. I also lengthened the connectors from 25.00mm to 25.15mm, which helps the loose joints connect better. But that little divot at the front of the circle still lets them slide out.

got some blood on me trying to put pieces together

very nice. been playing with it instead of studying. worth it

Nice job! Once I show it off to friends, everyone wants me to print one for their kids. I upped the infill and wall count to make sure it doesn’t break during assembly.

printed well, nice funny design

great profile!

Made this for my oldest daughter who loves fidget toys. This printed perfectly in a Purple-Teal-Burnt Orange Eryone filament. Thanks for sharing!

Nice!

Fun toy, printed the strong version and it went together well. Little stiff at first but it is loosening up some already.

Cool thing, and work fine !