Stitch Piggy Bank W/ Screw Top Head
Stitch Piggy Bank W/ Screw Top Head
Boost
95
123
33
Print Profile(6)
Full - 0.2mm layer, 2 walls, 5% infill
Designer
8.4 h
1 plate
Full Plate - 0.2mm layer, 2 walls, 10% infill
Designer
9.5 h
1 plate
Large Body - 0.2mm layer, 2 walls, 10% infill
Designer
5 h
1 plate
Large Coin Head - 0.2mm layer, 2 walls, 10% infill
Designer
4.6 h
1 plate
Click to see more
Open in Bambu Studio
Boost
95
123
33
5
277
189
Released
Description
200 mm (7.5 in) Tall
Stitch coin bank with screw top head
Use slim tree supports, especially on the head.
I made the coin slot 30mm X 5 mm. This made it big enough to take a US Dollar coin.
I have Uploaded the (container) body and the Coin slot head.
If you want a head without a coin slot it can be found here:
Stitch Container with screw off head by dohara1985 - MakerWorld
Commercial license
As of 2/25/24 my designs are no longer allowed to be sold commercially.
Do you want to sell prints of this model or any of my models? You can purchase commercial licensing at Patreon or Buy Me A Coffee. Earring Commercial Liscence is just $3 a month. A full commercial license for all of my designs is just $7 a month.
Comment & Rating (33)
All
Print Profile
Full - 0.2mm layer, 2 walls, 5% infill
I love it! Camel out great and smooth 😍 (handpainted after print)
1
Reply
love it!
0
Reply
Print Profile
Full Plate - 0.2mm layer, 2 walls, 10% infill
Alles Bestens
0
Reply
Print Profile
Full Plate - 0.2mm layer, 2 walls, 10% infill
awesome with mate pla !!!
0
Reply
slowed speeds down and it printed perfect
0
Reply
Perfect
0
Reply
Print Profile
Full - 0.2mm layer, 2 walls, 5% infill
0
Reply
Which filament is this? I love it!!
0
Reply
Print Profile
Full - 0.2mm layer, 2 walls, 5% infill
0
Reply
Print Profile
Full Plate - 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
Full Plate - 0.2mm layer, 2 walls, 10% infill
les support ne tienne pas impression échouée a 30%
The designer has replied
0
Reply
If supports are failing it is not because of the profile. Check your setting, your Filament and your adhesion.
Lots of successful prints, which points towards the issue towards most likely one of the things above. so please fix your ratings.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld