Fidget Toy: "The Finger Trap"
Copyright Claim
Fidget Toy: "The Finger Trap"
Boost
15
32
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
15
32
9
0
49
74
Released
Description
This one reminded me so much of an animal trap that I had to call it “The Finger Trap”.
This folds in 8 places, making it very tactile. It's great for single-handed or double-handed use.
As this has eight print-in-place joints, it will take a few minutes to free up each joint. Ensure that the print has cooled, and then start working each of the joints in very small amounts initially. After a few minutes, it will be pretty smooth.
Comment & Rating (9)
All
do you recommend printing it in matte or basic pla
The designer has replied
0
Reply
Either will do fine. Avoid silks as they do not have very good layer adhesion.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints nicely, a little stiff though which should loosten over time
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The links are somewhat tight, it needs a lot of break-in for it to work properly. Other than that, it's an easy print.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld