Pastamatic SKÅDIS Holder
Copyright Claim
Pastamatic SKÅDIS Holder
Boost
46
98
9
Print Profile(1)
0.16mm layer, 2 walls, 40% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
46
98
9
0
111
32
Released
Description
The Pastamatic by GekoPrime is a superb spool winder design, but it's a big thing to sit around when not using it.
This is my design which allows you to hang it on an Ikea Skadis peg board.
There are two separate mounts, and each one fits an optional bottom support piece (which depending on your printers tolerances can either be clipped in place, or fitted with a dab of glue).
Print Settings
- Layer height/Resolution: 0.2mm (or better)
- Infill: 40% Gyroid
- Material: PLA
- Supports/Skirt: Basic supports, works fine if you leave it on ‘auto’.
I've included the following files:
- STLs of all 3 items
- 3MF project file for Bambu Studio
I hope you enjoy printing and using my design. To help me keep designing and uploading more things, you can tip me via 'Buy Me a Coffee' here:
https://www.buymeacoffee.com/JoshForwood
Comment & Rating (9)
All
Print Profile
0.16mm layer, 2 walls, 40% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
Had to increase the infill strength. felt a bit weak.
The designer has replied
0
Reply
Still holding strong for mine 2.5 months later, but I guess the specific filament you use will also play a part (and the settings you'd used for printing the Pastamatic which would affect it's weight).
Hope you enjoy it! Happy printing!
0
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 40% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld