Yarn bowl Kitty


Print Profile(2)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
P1S, P1P, X1, X1 Carbon, X1E, A19.2 h
4.7
150% with AMS version
150% with AMS version
X1 Carbon, P1S, P1P, X1, X1E, A140.2 h
5.0

61
112
43
294
402
Released
Copyright Claim
Model
Comment & Rating
Remixes
Related Models

Model

Exact same model as source, just re-uploaded minus the grandstanding drama.

License CC BY

Yarn bowl Kitty
by vulg4r is licensed under the Creative Commons - Attribution license.


License

This work is licensed under a
Creative Commons Attribution

Comment & Rating (43)

0/5000

Model Comment

I used Neema3d Nova Marble PLA for this one. Added little support. Came out PERFECT!!

The designer has replied
0
Reply
Model Uploader

It looks awesome, especially with the marble filament, thx for sharing!

1
Reply

@NeoBlack thank you for the design bro

0
Reply
Model Comment

love it! thank you!

1
Reply
0.2mm layer, 2 walls, 15% infill

great print quality, the supports came of fairly easily too which was nice, I printed this with Bambu labs filament of matte lilac purple on a Bambu labs P1S has a slight visible line around the bottom half but that’s not a problem and can barely be seen, all the holes are smooth and look great I have attached some photos of my results with this profile 👍

The designer has replied
0
Reply

A very great result that looks fantastic, and is so clean. Top print!

0
Reply
150% with AMS version

adorable. will be a gift for a yarn addict.

0
Reply
0.2mm layer, 2 walls, 15% infill

all good, printed 2 models

0
Reply
0.2mm layer, 2 walls, 15% infill

Really nice but small

0
Reply
0.2mm layer, 2 walls, 15% infill

not bad, came out funky but probably the filament

0
Reply
0.2mm layer, 2 walls, 15% infill

overall great print. printed wirh silk PLA and had to slow it done to 50%. I'll probably tweak the settings a bit to get it perfect. will try again in regular PLA to see if it makes a difference.

0
Reply
0.2mm layer, 2 walls, 15% infill

0
Reply
0.2mm layer, 2 walls, 15% infill

the bottom portion didn't print right the bottom layer peeled off but other than that it was really good wife loves it

The designer has replied
0
Reply

@Ace This is the first time I've heard this, and I wasn't able to observe it myself. Maybe print with a brim next time. But your wife is happy, that's perfect ;)

0
Reply

Remixes (0)

There are no remixes yet