Phone Charging Stand for Sports Team Logos

Introducing a Sports themed wireless, magnetic phone charging stand. You can use the blank face (boring), or choose from one of the many sports team logos available. Even better, print a bunch out and change them out as desired. I have created faceplates for all NBA, NFL, MLB, NHL and many popular Soccer/football teams. They can be found via the links below.

MLB: https://makerworld.com/en/models/655834#profileId-582830

NBA: https://makerworld.com/en/models/655853#profileId-582859

NFL: https://makerworld.com/en/models/655862#profileId-582868

NHL: https://makerworld.com/en/models/655879#profileId-582893

Soccer: https://makerworld.com/en/models/656172#profileId-583197

There are two variants of chargers. With the charger on plate 1, the faceplate base has two holes in the bottom and simply sits on the posts located on the stand. For those seeking a sturdier option, plate two is designed for heat inserts so you can screw the base to the stand using m3 screws. Any length from 6mm to 12mm should be fine.  

Once installed the chearger holder slides up and down to achieve the optimal charging postition based on your phone size. To assist in holding its position the “bolt” slider can be slid into one of the slots to help hold it.

The stand has supports on either side as well so your phone can be positioned either vetically or horizontally.

The charger itself itself is 56mm across and 5.5mm deep.

It is slow charging so if you want a faster one look for the same or smaller dimensions.

INSTRUCTIONS:

After printing your desired version, insert the bolt into the slot on the charger holder. Then place the charger holder with the opening facing forward. Next rotate the charger holder so both tabs can slide into the slots on the inside of the base ensuring the side with the “bolt” is facing upward and the tab on the opposite side is partially positioned in one of the "bolt" slots. Now rotate the charger clockwise ensuring the “bolt” is fully retracted.

Once in place the charger holder should slide freely up and down the track.

After the charger holder is in place snap on the faceplate of your choice and enjoy.