90 Degree Clamp for Wolfcraft Clamps
Copyright Claim
90 Degree Clamp for Wolfcraft Clamps
Boost
6
24
3
Print Profile(1)
0.2mm layer, 2 walls, 25% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
6
24
3
0
20
17
Released
Description
These clamps are attachable on Wolfcraft clamps, just remove the green plastics and pull on the printed clamp parts. Works great and helps a lot, when screwing boards in an 90 degree angle.
Printable without supports.
Use more than 20 % Infill to get best strengths.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 25% infill
passt perfekt auf die zwingen. ich habe das Modell vergrößert, da ich größere zwingen nutze.
0
Reply
Print Profile
0.2mm layer, 2 walls, 25% infill
The designer has replied
0
Reply
Hey, werent you fully happy with the print? If there is something i can do better i would be glad to know :)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld