Pegboard Gridfinity Refined 4x2 Remixed by marciealana

Remixed by

marciealana

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill

Designer

3.8 h

1 plate

4.5(6)

Open in Bambu Studio

Boost

Released

Description

I use Gridfinity Refined for bases and baseplates. 6x2mm magnets are either friction or snap fit. I do use a bit of hot melt when the snap fit isn't as snug as I'd like. There are a few Gridfinity pegboard mounted baseplates, but none were this particular style.

There is now. I've left the keyed openings on the outside of the baseplate, but I doubt they are functional. Made for the 1 inch pegboard of the US.

Comment & Rating (10)

@LongracksLabs

Print Profile

0.16mm layer, 2 walls, 15% infill

@LongracksLabs

Great print. I am curios what the 'Generic Cube' is for in the model? I've not seen that before.

The designer has replied

@marciealana

In Bambu Studio, when you load an STL, you can add parts, modifiers, and support zones to it with a right click on the model. "Generic cube" is one of the basic types you can add. In this case they are support blockers. Any part of the model that is inside the cube, will not get supports. Why did I do this? Because Studio will attempt to support the gaps in the bottom of the base plate, and they are ugly, a PITA to remove, and unnecessary. They were added to make printing easier for everyone.

@LongracksLabs

Replying to @marciealana :

thanks for that info! I’ll check that technique out.

@newpain001

Print Profile

0.16mm layer, 2 walls, 15% infill

Doesn’t fit on a pegboard

The designer has replied

@marciealana

Pegboards come in several hole styles/dimensions. This one was made for the US 1 inch between holes board.

@GeekMechanical

Print Profile

0.16mm layer, 2 walls, 15% infill

This print has proven to be highly effective for my workshop needs. I printed two units to efficiently organize and store my collection of screwdriver bits.