Tesla Model Y hitch tool
Copyright Claim
Tesla Model Y hitch tool
Boost
35
117
21
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
35
117
21
7
218
273
Released
Description
Tool to remove the hitch cover from the rear of a Tesla Model Y
Comment & Rating (21)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
Printed perfectly but unfortunately the tip broke off when I tried to remove the back plate on my Tesla.
I will try to increase the infill and hopefully it works out!
2
Reply
had the same
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
just perfect
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
worked, but one almost broke
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
great print but sadly snapped after a few tries
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
print is good but needs Asa or abs to not break at least for me
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
I used ASA at 50% infill, but it still broke the first time I used it unfortunately
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Great tool. Thanks!
(Edited)0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld