Silica Dryer Spool Funnel with Thread Remixed by matziwe

Remixed by

matziwe

3D Printer>3D Printer Parts

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.12mm layer (variable layer height), 4 walls, 15% infill

Designer

57 min

1 plate

4.9(10)

Open in Bambu Studio

Boost

Released

Description

This is a remix of the original funnel by Kyaenos for his Silica dryer spool. I added a thread to screw it onto the dryer spool. It fits the spools thread quite well and therefore the funnel cant fell off while the silica is being filled in.

Print the funnel up side down, so the thread is at the top. I used variable layer height, so the thread is printed fine and save printing time at printing the lower funnel part.

Comment & Rating (11)

@pieropenguin

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

printed in eSun PLA+ in white. fits well in the main body that's printed in PETG.

@Print2Repair

Boosted

Very handy and does the job ! Thanks

@tonsoffun2886

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

works great, way easier to load with the funnel locked into place

@Print2Repair

Boosted

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

Perfect fit for the Silica dryer spool V2 !

@pebbles8220

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

The funnel printed perfect and it screwed onto the Silica Dryer with no problems whatsoever. Nice print.

@Mace3D

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

Easy print, fits perfect!

(Edited)

@AlexStuber

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

Fit perfect

@GalaxyZipper

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

easy print, thx!

@Magnus_

Print Profile

0.12mm layer (variable layer height), 4 walls, 15% infill

pretty good. There were some print issues at the start of the flare out and i dont know where thez come from. Not perfect but almost so and absolutely usable