Meet Reggie The Robot! - The loveable, print in place, fully jointed robot toy!
Easy to print, has been tested down to 60% scale but your printer has to be really dialed in for success.
80% Scale Takes Roughly - 1h:22m
100% Scale Takes Roughly - 2h:15m
Bear in mind 100% scale is still small! - 73mm from head to toe, so you may want to scale up to 200/300% at a 0.3 layer height, for a really robust Reggie.
I really hope you enjoy this design! It's taken a fair few iterations to get a reliable, robust print and I'm really happy with the end results.
Any questions, please comment and I'll reply asap :D
Have Fun!
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:Various PLA+ Multiple
Notes:
A good first layer is essential. Make sure there are clear gaps around the joints, otherwise breaking them free can be tricky. If you struggle with this, raise your Z offset by 0.05mm And test again.