Bambulabs X1C PTFE-Bracket - Extended Version Remixed by Twotone74

Remixed by

Twotone74

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill, 5mm Brim

Designer

30 min

1 plate

4.7(7)

X1C, 0.2mm layer, 2 walls, 7% infill, .4 nozzle

31 min

1 plate

4.3(3)

Boost

129

336

Released

Description

I liked the original bracket, but it didn't solve the problem that the PTFE-Tube rises upwards and collides with the glasstop (ok, not so easy as before) or the LED-Frame that I installed (https://www.printables.com/de/model/365027-bambulab-top-glass-riser-4-cob-led-remix-with-led-).

I'm not sure if this is really a problem, but with a little modification I was able to prevent this. As you can see at the pictures, my version has a little longer arm, so that it can keep the PTFE-Tube horizontal. And: it is easyer to print, I didn't need a brim.

Comment & Rating (14)

@FatherGroup

Print Profile

0.16mm layer, 2 walls, 15% infill, 5mm Brim

Thanks

@jgelwix

Print Profile

0.16mm layer, 2 walls, 15% infill, 5mm Brim

@HardwareMaster

Thanks for this design. I printed one but it still seems to have the same problem sadly. The problem was not too much the top part being angled, it is rather the bottom part which goes into the extruder. When it gets stuck, I this PTFE bracket push back/tilt it towards the back of the printer and then click retry, then AMS is able to pull the filament back. Is there something recommend to solve the problem also at the bottom?

@user_973606146

Print Profile

0.16mm layer, 2 walls, 15% infill, 5mm Brim

nice!

@arnelenz1986

Print Profile

0.16mm layer, 2 walls, 15% infill, 5mm Brim

thanks for sharing it

@Maxime.M

Ne fonctionne pas touche le châssis de la machine quand la tête est au maximum vers l’avant

@Juiceknuckle

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill, 5mm Brim

printed flawless in petg

@XyphoidProcess

Works good. Just one question: Whenever the printhead goes all the way to the front, the bracket gets knocked off by the top of the front of the printer. Is the bracket too high or am I doing something wrong in the printer settings?

@Gmoney316

what material is best used for this