Christmas Gift Box (Functional) Multi-Piece No AMS Needed
Remixed by
Copyright Claim
Christmas Gift Box (Functional) Multi-Piece No AMS Needed
Remixed by
Boost
88
183
45
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
2.8 h
3 plates
Open in Bambu Studio
Boost
88
183
45
0
340
561
Released
Description
Remix of the first Christmas Present I designed. This version is functional and has snap on pieces to allow for the top and bottom pieces to be separate. No AMS is needed. Adding a small amount of glue will help to permanently fixture the pieces together. Add a dab of super glue to hold each piece together permanently. When assembling the side ribbons into the box, make sure to place the angled side down of the ribbon for proper alignment and fit.
If you would like to use the physical prints for commercial purposes or would like to support me please visit my Patreon. Commercial License subscription can be found there. https://www.patreon.com/CreativeRenditions
Comment & Rating (45)
All
printed great
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Was easy to print, and looks nice
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Super rendu
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Nice
(Edited)
0
Reply
Printed beautifully with Bambu Sparkle Red. Thanks for the blueprint.
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
perfekt geworden 👍🏻👍🏻
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Nice and cute little box. The bow hole is a little big for the section and make it fragile. Overall is verry good. Thanks for sharing.
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
parts fits well together
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Nice design only the bow is a little bit weak.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld