Filamentholder/ Filament-storage / Dry-box by Tom.john98

Tom.john98

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.16mm layer, 3 walls, 15% infill

Designer

10 h

2 plates

5.0(4)

0.16mm layer, 3 walls, 15% infill, 9mm lid brim on lid only

11.3 h

2 plates

Open in Bambu Studio

Boost

114

Released

Description

This filament holder will keep your filament dry and can be used with every printer.

It should fit Spools up to 200mm diameter but also the small 250g Spools. To keep the Filament dry I added a desiccant storage in the middle.

To get the filament out of the opening when you changed a spool is a littel bit challenging but doable.

In the Filament output you can insert a PTFE Tube with a outer diameter of around 4 mm. I reused the old one from my P1P for example.

The side-cover is screwed on and yours will differ from the one in the pictures, so you have a better grip to screw it.

filament

dry box

desiccant

Comment & Rating (4)

@user_4041828596

Print Profile

0.16mm layer, 3 walls, 15% infill

Tip top. Funktioniert Einwandfrei und ist schon glatt.

@ShayneTroxler

Print Profile

0.16mm layer, 3 walls, 15% infill

The body printed good out of generic pla. The lid, not so much. I reprinted it with Bambu Labs matte pla out of the drier. It printed perfect. If you are careful printing the threaded lid it will make a good dry place to store a roll. My only suggestion as to the design is to make the threads less fine. it’s hard to get the top started to screw on and it requires more revolutions to tighten it than nessasary.

(Edited)