Print Profile(2)
0.2mm layer, 2 walls, 15% infill
19.3 h
2 plates
0.16mm layer, 4 walls, 15% infill
27.1 h
1 plate
Open in Bambu Studio
Boost
41
85
15
2
281
83
Released
Description
Piggy money.
Prepared to be printed as a single piece and the eyes, nose and crown painted.
Comment & Rating (15)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
very good
0
Reply
Print Profile
0.16mm layer, 4 walls, 15% infill
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
Support Issue:No advice how to print it, creator doesn’t respond to comments and messages.
“edit” he says to me that some supports are needed”
I printed it with supports only for the under side
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
开启支撑里面怎么拿的出来吗
0
Reply
that’s the question I have
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice and cute design. hard to remove the support, even when Support PLA is used. Lower scale not recommended.
0
Reply
Support needed or not? When yes, how do you remove it from the inside??????
0
Reply
你好，需要开启支撑吗
0
Reply
Print Profile
0.16mm layer, 4 walls, 15% infill
Support Issue:Didn't work for me
0
Reply
Boosted
Print Profile
0.16mm layer, 4 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld