Search models, users, collections, and posts
Pokeball Keycap without support
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
11.5 h
2 plates
45 degree less colour changes 0.2mm layer, 2 walls
4.1 h
2 plates
Open in Bambu Studio
Boost
671
1775
28
14
841
248
ReleasedÂ
Description
Hi everyone ~ đ
I used solidworks to design a pokeball keycap that can be installed into your mechanical keyboard.
I adjusted the dimensions to maximize the sphere of the pokeball without affecting the installation
Easy to print, no support required.
AMS requiredďźBlack Red White PLA
You can use the variable height Settings to optimize the effect of the top.
You can also write any text you need in bambu studio, such as F1~F12.
I look forward to your comments and suggestions and don't forget to share with me pictures of your keyboard.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (28)