Stacking toy set
Copyright Claim
Stacking toy set
Boost
115
192
16
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
17.1 h
9 plates
Open in Bambu Studio
Boost
115
192
16
7
170
206
Released
Description
Stacking toy
Toy was prepared for printing piece by piece and subsequent assembly.
I will post more work so if you like my modeling, follow and download:)
Hope you like it
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 30% infill
Turned out fantastic. I made the handle out of TPU.
1
Reply
I made twice as many shapes and could have made another set for them all to fit in the container.
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 30% infill
Printed great,
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
nice clean print
0
Reply
8 of the 9 beds printed out fantastic. I doubled up the number of shapes and printed each plate in a different color filament. The only issue, and it was a big one, was two failed attempts at printing the "bucket" part. The first time was a failed bed adhesion right near the end of the print that generated a noodle mess. I attempted it again, without a color change for the added text, and it held to the bed great. but, the inside of the bucket turned into a noodle mess and thin bottom. The support remained perfect, but it did not help. I may try to print an insert or something. Still usable though. Thanks for sharing!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Perfect!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Really nice!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Bed Adhesion Issue
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld