Search models, users, collections, and posts
Protractor set
IP Report
Print Profile(4)
0.20mm layer, 6 walls, 20% infill
Designer
1.7 h
1 plate
Protractor design #1. 0.2mm layer, 6 walls, 20% infill
Designer
40 min
1 plate
Protractor design #2. 0.2mm layer, 6 walls, 20% infill
Designer
36 min
1 plate
0.2mm layer, 2 walls, 10% infill
1.5 h
2 plates
Open in Bambu Studio
Boost
322
769
85
24
1.8 k
1.2 k
Released
Description
This set features two protractor designs with three different “snap in” hand designs.
To snap in hands, it is easier to set one side of the “nub” in and push the other side in.
To remove hands, it is easier to use the nub of another hand or pen to push one side of the nub out slightly and then it should pop out easily.
My test prints
- Generic white PLA and generic black PLA were used.
- AMS was used
- 0.20mm layer height
- 6 Walls
-10% infill
For no AMS
- print Protractor alone
- swap from white to black after layer 13 or after 2.60mm layer height
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (85)