Good profile, though it would benefit from more infill. I printed two 17cm models and both had a tiny hole near the top of one eyelid where the top layer bridging wasn’t sufficient. Also, like the smaller versions of the same model, one of the two models had a leg break when carefully removing the prints from the plate. (fixed with PLA Gloop)
On a very positive note, the supports are VERY easy to remove and do a good job.
Printed pretty well, though the legs and tail are very fragile. I printed two on the cool plate with glue, but broke one when trying to gently take them off.
Still a pretty good print profile.