AMS Helper with Logo (Remix)
Remixed by
Copyright Claim
AMS Helper with Logo (Remix)
Remixed by
Boost
72
151
46
Print Profile(3)
0.2mm layer, 3 walls, 30% infill
Designer
2.5 h
1 plate
X2 with border - 0.2mm layer, 3 walls, 15% infill
1.2 h
1 plate
0.2mm layer, 2 walls, 10% infill
1.9 h
1 plate
Open in Bambu Studio
Boost
72
151
46
0
291
332
Released
Description
Ich habe den AMS Helper ein wenig modifiziert, damit er mit den AMS Feeder-Tasten funktioniert.
I modified the AMS Helper a little to make it work with the AMS Feeder buttons.
Original Files on MakerWorld
AMS Helper Guide
https://makerworld.com/de/models/41406#profileId-41677
AMS Feeder Buttons
https://makerworld.com/de/models/41859#profileId-42399
Comment & Rating (46)
All
I printed and tried it but when I close my AMS lid it pinches the filament between the lid and helper (print). Did I do something wrong?
1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Looks good.
(Edited)
0
Reply
Print Profile
X2 with border - 0.2mm layer, 3 walls, 15% infill
😉👌🏿🔥🙏🏿🙏🏿
0
Reply
Print Profile
X2 with border - 0.2mm layer, 3 walls, 15% infill
printed nicely, just received the rods in the mail. will cut and install tomorrow
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
perfect
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
I haven't tried it yet, but it seems really well made.
Congrat and thank you for sharing and the job!
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
0
Reply
Print Profile
X2 with border - 0.2mm layer, 3 walls, 15% infill
doesn't fit....too high
1
Reply
Print Profile
X2 with border - 0.2mm layer, 3 walls, 15% infill
passt leider nicht mit silika einsetzen mehr
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
nice
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld