Headphone holder
Remixed by
Copyright Claim
Headphone holder
Remixed by
Boost
43
80
33
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
43
80
33
3
284
277
Released
Description
Headphone holder with cord hanger.
Printed on Bambu labs P1S in a little over 2 hours.
Sharing this from philbarrenger's account on thingiverse. Full credit goes to him.
Comment & Rating (33)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I know that's not where the headphones should be put, but they fit nice in there and are more secure from possible bumps/drops.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed in PETG
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
great print!!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
solide et très pratique
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very high quality build. with a smart design
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I probably should have used a harder plastic. basic pla bends too much when I attach it to the desk.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A little tight but works great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
quite good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld