Hellraiser (HueForge print)
Hellraiser (HueForge print)
Boost
18
27
5
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
5 h
1 plate
Boost
18
27
5
0
31
14
Released
Description
colors used
pla black
pla Egyptian blue/light blue
luminous green/white
if you don't have luminous or don't want it to glow just use white instead!
Comment & Rating (5)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
Only had one issue bottom left but that is possibly my fault, other than that it looks great.
(Edited)
The designer has replied
1
Reply
it looks good, that bottom left corner is odd. kinda looks like a blob got stuck right there and lifted up or something. I never seen a hole blown out like that on any of mines.if it was mines I would put a piece of tape across to make a straight line right above the hole and cut it with scissors.
(Edited)1
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
No more
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld