Hueforge Wall Display.

Table Stand Base also available here:   Table Stand for Hueforge Modular Display System.

I have created a modular adjustable display for your Hueforge art pieces. This display will work with wall art that is 2-8mm thick, and will work with multiple sized in width and height to accommodate almost any sizes that need to be displayed.

The horizontal pieces slide from the top down on the Slide Rails and sit on the top and bottom of each piece supporting it and holding it in place.

a complete unit is on plate 1 and is enough to display 3 or 4 pieces on 1 mount depending on the size. the other plates have the various sizes of additional and optional pieces if you want to have various sized or make the display longer or shorter by substituting components.

Mounting: Can be mounted using the screw holes, or a similar option would be to use command strips top and bottom for a secure fit, depending on length consider a middle one as well.

Component List:

Vertical Slide Rails: Configurable to most any length using the 3 sized an the lock joints.

Top Slide Rail (With Mounting hole)

Bottom Slide Rails. (With locking pin and mounting hole)

Middle slide rails (3 different lengths to choose from to adjust as needed to fit your art pieces.)

Horizontal Supports: you will want 1 for the top and 1 for the bottom, and if you have more than one piece you'll need 1 in between. These can be combined however you see fit.

200mm Width (Works for the Standard Landscape Hueforge size)

130mm Width (Works Great for Portrait orientation pieces)

50mm Widths (works great for Odd sized pieces, circles and object shaped art pieces, supporting the top and bottom of each piece)

For the bottom piece with the locking pin,   the pin can be a little tight and might need to clean the corners.   I recommend inserting it from the back (beveled side of the slide rail) with the angled portion going in first,  then push down against a flat surface until it's full seated.  This pin act as a base support so the rails can't slide off the bottom. Reference photo below for proper orientation.

Slide the Supports (how ever many you need) over the Slide rail,   it's a snug fit so they don't just slide around and stay straight. 

Rails can Slide up and down to adjust for the height of the Hueforge Art Piece.   Select the desired horizontal support for you needs. 

Optional Parts:

I have created a 400mm horizontal support that allows you to display 2 Hueforge 200mm Wide prints side by side.   I added a print profile for these longer supports.  they assemble using a dovetail.  they are tight but snap together with a little effort.   The 2 photos that will be side by side need to have the same height for these to work properly.  

Here is and example of what you can do with them.

I have created a 600mm horizontal support that allows you to display 3 Hueforge 200mm Wide prints side by side.   I added a print profile for these longer supports.  they assemble using a dovetail.  they are tight but snap together with a little effort.    The 3 photos that will be side by side need to have the same height for these to work properly.   the display below is 44" tall x 23-5/8" (600mm) wide  and is holding 15 hueforge prints.   (fastened to the wall with 3 small command strips).