When there isn't much filament left in the spool, clips attached to the edge aren't very effective. So I designed this one, named Baby Carrot, to be attached on the inside the Bambu Lab Spool using the holes already present, without the need for glue or anything else to stay in place.

The main advantage of this clip is that you don't need to remove it before using the spool in the AMS because it does not interfere with rotation. Furthermore, thanks to the rounded shape, this clip does not block the filament during unwinding.

The only drawback is that on full spools you won't find room to snap this clip until you've used up enough: in this case you can print one of the two clips that I designed specifically and which you can find at this link:
https://makerworld.com/it/models/59601

You can then leave it assembled until all the filament runs out. And when you want to remove it, just use any scraper to lift the edge and detach it.

Warning: before before downloading and printing SPAM profiles, please check that when ★ 𝐅𝐚𝐬𝐭 is written it is really faster and not 30% slower at printing. Also make sure it was actually printed by author and that the photo used is not only a copy of the print from the original profile!