360 Swivel Hanger ⬣ Print in Place
Copyright Claim
360 Swivel Hanger ⬣ Print in Place
Boost
52
113
13
Print Profile(4)
360 degrees hanger, 0.12mm layer, 2 walls, 10% infill
1.4 h
1 plate
Fixed to rotate, more accurate, less time and material, still strong enough, 0.16mm, 3 walls
1.5 h
1 plate
hanger fix Point, 0.2mm layer, 7 walls, 30% infill
1.5 h
1 plate
Full Printbed, for P1P/P1S or without flow calibration for X1
1.5 h
1 plate
Open in Bambu Studio
Boost
52
113
13
0
86
76
Released
Description
Swivel works best at .20mm layers.
Comment & Rating (13)
All
Print Profile
hanger fix Point, 0.2mm layer, 7 walls, 30% infill
Oh c'mon! The hanger is a beautiful design, but why advert it as 360 rotating if just from layer one (with your profile) it will fuse all the hinges?
What a pity
(Edited)
The designer has replied
0
Reply
Hello ValdiLab,
After receiving your feedback, I noticed the issue with my clothes hanger after printing with my print profile. Upon receiving your feedback, I updated the description of the print profile to "attachment point."
For my next step, I have created a new print profile and will conduct further tests to ensure that the clothes hanger can rotate 360 degrees.
best wishes,
Fredwood6000✌️
0
Reply
Replying to @Fredwood
The next print job with the new print profile is being started right now. ✌️
0
Reply
I'll try, hope this pity is fixed now
(Edited)
0
Reply
Print Profile
Fixed to rotate, more accurate, less time and material, still strong enough, 0.16mm, 3 walls
these are great wife loves them I am print a lot of them now she put in her request
The designer has replied
0
Reply
Thank you for printing it!
0
Reply
Print Profile
360 degrees hanger, 0.12mm layer, 2 walls, 10% infill
Gut
1
Reply
Print Profile
Fixed to rotate, more accurate, less time and material, still strong enough, 0.16mm, 3 walls
The designer has replied
0
Reply
Thank you!
0
Reply
Print Profile
360 degrees hanger, 0.12mm layer, 2 walls, 10% infill
1
Reply
Print Profile
hanger fix Point, 0.2mm layer, 7 walls, 30% infill
1
Reply
Print Profile
hanger fix Point, 0.2mm layer, 7 walls, 30% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld