Skadis 3 / 4 Nozzles Holder for Bambu Lab A1 (mini)
Copyright Claim
Skadis 3 / 4 Nozzles Holder for Bambu Lab A1 (mini)
Boost
126
259
65
Print Profile(2)
0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
2 plates
4 Nozzles - 4 walls, Cross Hatch infill
35 min
1 plate
Boost
126
259
65
2
441
268
Released
Description
Holder for 3 or 4 Bambu Lab A1 (mini) nozzles for Ikea Skadis.
No support needed.
The holder is quite flat, so I recommend using the Skadis Lock Plug (10mm) to prevent the holder from sliding out of the pegboard holes.
Comment & Rating (65)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
Great print! Thanks.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
a Little tight
0
Reply
Thanks.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
super
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
perfect fitting
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
good
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
As easy as it looks. 5*
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
tres bon profile simple a imprimer
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Works alright but nozzle is a bit hard to pull out since it is flush against the board and limited room for fingers.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Prints well, fit to the Skådis board is quite tight though. This makes it hold on super well but might be a problem if you have high filament shrinkage.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRemixes (2)
Related Models
© 2024 MakerWorld