Monkey Dice Tower

This is a funky dice tower based on the old falling monkey game where a lot of rods roll your dice for you.

It's also a built in overhang test for your printer. If you have problems with the overhang you might need some small supports in the middle of the arch. My printer just managed it but it's possible it might fail.

The smallest rods (rod_1) are long enough to reach directly across but if you want some bending action consider printing at least rod_3. I'd suggest just printing all once to see how they work with your filament!

Depending on your dice and rod placement you might block your dice from falling through so watch out :)

Print Settings

Resolution: 0.2mm

Infill: 20%

No Supports