Search models, users, collections, and posts
Spool Guard
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
5
10
2
0
9
5
Released
Description
Spool Guard
A spool guard to keep your filament spools from falling off mid-print.
After using @Generic User's "X1C/P1S Side Spool Remodelled" I noticed that some filament spools almost fell off mid-printing due to their larger holes compared to the original Bambu spools.
This issue is not the fault of Generic User's model but rather the original spool holder itself. I only noticed it because the spool was on the side of my printer instead of the back. To solve this, I created this spool guard. It's easy to attach and remove.
Print Settings
Use tree supports (you can easily remove them with a toothpick)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)