This is a set of three wizards casting lightning spells. All prints will use the same print settings and filament. There is also a simple if desired, I have been using self adhesive magnets to hang them on a refrigerator.

Print at 100% infill with a layer height of 0.16mm with a base layer of 0.2mm

The Model is 150x150mm in size
You may print at higher layer heights below the Min Depth of 0.52mm
The Max Depth is 1.8mm and the Actual Depth is 1.8mm

Filaments Used:
PLA Elegoo Rapid Black Transmission Distance: 0.1
PLA Elegoo Rapid White Transmission Distance: 4.9
This print uses 2 unique filaments

Swap Instructions:
Start with Black
At layer #7 (1.16mm) swap to White for the rest.