Pikachu wire frame // <14g // no support needed
Copyright Claim
Pikachu wire frame // <14g // no support needed
Boost
61
102
5
Print Profile(1)
0.2mm layer, 6 walls, 20% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
61
102
5
1
102
15
Released
Description
Pikachu Wire frame // <14g // no support needed
Beautifull piece of art that is loved by young and old!
Gonna print them all
Printed in 2,5 hours.
I recommend using adhesive spray or a glue stick, but i added a bram so it is also possible to print it without.
Comment & Rating (5)
All
加了胶水，连续试了4次热床无法附着
The designer has replied
0
Reply
您是直接从我的打印文件中打印出来的吗（并按照我的建议使用了喷胶）？
否则，如果您自己切割模型，您需要将模型平放在最大的表面上，然后将 Z 高度降低 1 毫米。这样，模型就会平整地放在构建板上，同时还能使用帽檐。
试试并告诉我是否有效😜。
0
Reply
Boosted
Lovely design
1
Reply
Print Profile
0.2mm layer, 6 walls, 20% infill
Bed Adhesion Issue
The designer has replied
0
Reply
Did you print it straight from my print profile (and use adhesive spray as I suggested)?
Otherwise if you slice the model by yourself, you need to lay it flat on the biggest surface and then reduce the Z height by 1mm. So the model will be flatter on the build plate and use a brim as well.
Try and let me know if it worked😜
0
Reply
No more
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld