Fidget Gears! Remixed for more tactile feel, less flex. Print in Place.
Remixed by
Copyright Claim
Fidget Gears! Remixed for more tactile feel, less flex. Print in Place.
Remixed by
Boost
42
92
44
Print Profile(1)
0.17mm layer, 3 walls, 15% infill
Designer
57 min
1 plate
Open in Bambu Studio
Boost
42
92
44
1
129
268
Released
Description
Hi !
This is a DJ Remix on the original from NinjaDuck prints:
https://makerworld.com/en/u/2630895803
So all credits where they are deserved and check out his page! :)
I wanted a more of a tactile feel so added 2 extra lines ontop with differing height.
They also decrease the flex in this model slightly
As with my print profile on the original, my settings are for quality and durability and the speed of the print comes second
Hope you enjoy and will leave you with this James May quote
"Oh, C*ck..."
Comment & Rating (44)
All
Print Profile
0.17mm layer, 3 walls, 15% infill
Printed it slower, but came out great.
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
printed great! easy snap to get it all moving. printed on P1S
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
Print came out visually as pictured, but did not actually spin. The gears did not have enough clearance. When trying to spin them, it took considerable force. So much that the gears broke off. It appears that one side was pretty functional and able to spin in place, but the other one is juiust a little off… it’s stuck to the internal axle, even now while broken it’s still hard to separate..
(Edited)
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
beautiful, works very well
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
My second 3D print. It spins perfectly.
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
turned out pretty well printed in PLA-CF
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
great print
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
A fun little gadget. I ran the edge of a sheet of paper between the gears, and it crimped the paper. Another cool feature.
1
Reply
Boosted
Print Profile
0.17mm layer, 3 walls, 15% infill
Feels great and prints well.
0
Reply
Print Profile
0.17mm layer, 3 walls, 15% infill
not bad at all
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld