portable mushroom lamp

Remixed by
Copyright Claim

portable mushroom lamp

Remixed by
Boost
1
0
0

Print Profile(0)


Add the first print profile to earn points

Boost
1
0
0
0
1
0
Released

Description

Voronoi Mushroom Lamp Remix

This design is a portable iteration of the classic Voronoi mushroom lamp. It features a dedicated compartment for a battery, a USB charging port, and a switch, all neatly concealed beneath a screw-on lid to maintain an elegant aesthetic while housing the electronics.

the 18650 li-ion battery that powers 1 single 1w led with a 20ohm resistor will shine light for 3 days non stop on a single charge. great for those 3 day benders at a bushdoof. 

solder the positive end to the switch then to the 10 (or 20) ohm resistor then to the positive end of the led.
solder the battery to the board. feed wires through hole. push in place. use a small flat head screwdriver between the back of the charge board and the plastic to pry it down, you might need to heat up the model a little to push it in. use hot glue to keep it secure if you push it down and moves when you plug it in. there are 4 tiny notches in the corners that should be cleaned out before you push it down. you might need to heat up the model a little to push it in. 

The stem underwent a complete redesign to accommodate these new features, while the rest of the lamp retains its original charm. For optimal print quality, the following settings are recommended:

Stem: 10% infill
Lid: 10% infill
Mushroom Head: 0% infill
Support structures are not required for the head, but are necessary for the dome. Included in the package is a .3mf file with pre-positioned stem and gills, along with a preset color change. Refer to the accompanying images for guidance on support placement and painting.

For structural integrity, the model incorporates:

Wall Loops: 3
Bottom Layers: 3
Top Layers: 3
While these settings generally suffice, you may opt for additional layers for enhanced durability. The feet are secured with hot glue for stability. Assembly is designed to be intuitive with parts that snap together seamlessly. However, for a more permanent fixture, consider melting the head onto the gills post-assembly to prevent detachment.

BOM:
battery 18650 lithium-ion:

https://www.aliexpress.com/item/32820520007.html?

10ohm resistor:

https://www.aliexpress.com/item/1005001652314923.html? 

1w led's:

https://www.aliexpress.com/item/1005006282400303.html?

switch 10*15mm SPST 2PIN ON/OFF G130 Boat Rocker:

https://www.aliexpress.com/item/4000122284566.html?

Type-c / Micro USB 5V 1A 18650 TP4056 Lithium Battery Charger Module Charging Board With Protection:

https://www.aliexpress.com/item/1005006655376015.html?

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more