Thermometer / Hygrometer Holder for Honeycomb Wall | HSW
Remixed by
Copyright Claim
Thermometer / Hygrometer Holder for Honeycomb Wall | HSW
Remixed by
Boost
8
34
11
Print Profile(2)
Regular 0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
Compact 0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
Open in Bambu Studio
Boost
8
34
11
0
28
16
Released
Description
I remixed the great design by Printosaurus for the Honeycomb wall.
I have created two versions, the regular and the compact one. The compact version hides the mount completely behind the body, but is less stable. When in doubt, I recommend choosing the regular version.
Both versions print without supports in the given orientation.
Comment & Rating (11)
All
Print Profile
Regular 0.2mm layer, 2 walls, 15% infill
Works as intended!
The designer has replied
0
Reply
Thank you for the feedback. Was there anything you were unhappy with, that made you go for 4 stars?
0
Reply
Replying to @Replica4292
I had to increase the infill as the first print snapt at the back where the Hex connects to the frame. Sorry for the delay.
0
Reply
Replying to @MechaMaker
No problem. Thanks for sharing! I will think about how to make it more stable.
0
Reply
Print Profile
Compact 0.2mm layer, 2 walls, 15% infill
a litle bit lose on hex but tape will fix it
(Edited)
0
Reply
Print Profile
Regular 0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you for the feedback. Was there anything you were unhappy with, that made you go for 3 stars?
0
Reply
had the failed to retract and hit cancel print by mistake.
0
Reply
Print Profile
Compact 0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for the rating :)
0
Reply
Print Profile
Regular 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld