2024 Paris Olympic Flag

These flags print flat to minimize number of color changes thus decreasing both printing time and filament waste if they were printed vertically instead with the wave already to them. In order to form them to be wavy, use this form which you print in PETG to bend https://makerworld.com/en/models/515393#profileId-431664

Print the flags face down like in the supplied print profile to get a better front surface finish. Print them in PLA so they can be heated and pressed into shape post process. The flags print as solid plates as I tried (accidently) with just infill on one print and it did not look or bend as nice.

Note that one can clone the flag and print two on same build plate for P1P, P1S, and X1C if want two of them.

To bend with printed form, heat flag with heat gun back and forth a little while until flag is softer then quickly apply top form and make sure the lip on it catches the bottom of flag and press up and check that top of flag is flush with top of form. I clamp mine and let it sit for several minutes to cool down and keep the wave form but one can also just hold for a minute or two. All the flags in my profile are designed at the same size to work with the same form.