Lucky Bamboo light support straight
Boost
1
0
0
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
4.1 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
2 plates
Open in Bambu Studio
Boost
1
0
0
0
0
0
Released
Description
I designed this support to keep straight my overgrown lucky bamboo 'cause i love it too much to trim it.
The first plate is the support itself which is 15cm long.
The second plate is the support extension, it is 20 cm long and you can just snap it on the support.
Potentially you could even stack the extension over itself since the tolerance allow it.
The support fit thightly on my bamboo but if you find it loose i suggest to stuff the internal section with some paper or leaves.
Boost Me
Thx so much for the appreciation! ^‿^ Hope you enjoy the model!!
Comment & Rating (0)
All
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld