I liked the V2.4 top hat mod, and decided to make one for the Micron as well. This is designed for the 180 version, I will likely also add the 120 and 160 versions soon. These are designed to print flat and will fit on the Micron+ build plate.

There is a right and left end with a common middle section. The same applies for the panel retaining rails. The middle section has the Micron logo insert. The top panels rails are meant to compliment the bottom skirt accent to tie the aesthetic together top to bottom.

I have also included an alternate front set to work with the Mini Fridge door by TheVoronModder. It adds a ledge to cover the front extrusion on the door.

BOM:

m3x5x4 heatset x20

m3 nut x20

NDN (no drop nut) x20 (check out my 10mm version here)

m3x8 screws x40

1mm thick foam tape (optional)

Parts are in the correct orientation and have support included as needed. I printed them with 3 walls, 5 bottoms, 4 tops and 25% honeycomb to get the effect you see in the pics. I used a clear ABS for the first 5 layers to allow light to pass, but still have a sealed chamber. Adding the needed NDN is pretty straight forward by just loosening the top rails and z idlers as needed to slide them in.