Credit to the original author, MyStoopidStuff, the original can be found at: LINK

Changes in this remix:

• All dimensions, changed to fit around the Uplift V2 frame's undercarriage around the PSU cable (Tallest point) too
• Magnet structure removed and inside squared off for cleaner printed corners, though less strength possibly

* Model prints without supports, as seen in photos.

REQUIRES

• M6 Spacers 2mm - 10mm by Geek3DUK - MakerWorld
• M6 Bolt 13mm by SMichaud - MakerWorld
• M6 Nut for Uplift V2 Railing Remixed by V - MakerWorld

How to install: Place Nut (Above) on rail opening and maneuver behind the holes on the rail where you'll mount it, make sure the bolt hole is on the bottom not the top for v2 desks and that the nut is facing toward you, then hold cover over railing, slide washer onto bolt and firmly tighten onto bolt, its recommended you start from the center two points as to provide structure for the outer ones.

This model is under the Creative Commons - Attribution - Non-Commercial - Share Alike license, more information here: LINK