I created this set of Hueforge bookmarks so that all 4 can be created at once with the same layer settings. This print uses 6 colors, but because Hueforge prints by layer you can still print this with a single AMS or no AMS.

If you do not have an AMS, then you simply need to manually swap the filament each time it would need to be changed. If you have only 1 AMS the process is slightly more difficult.

Slice the model as normal, but add a pause at layer 11 (0.96mm) just before the color change to orange to swap two one of the completed colors (lighter blue, darker blue, or black) and swap in the orange and white. You will need to decide which slot is going be replaced with which color before starting the print so don't forget which slot you chose for orange and white.

How to Print

Start with Black

Layer 6 switch to Dark Blue

Layer 8 switch to Blue

Layer 10 switch to Red

Layer 12 switch to Orange

Layer 20 switch to White

Filaments I Used

Black - Duramic PLA Black

Dark Blue - Bambu Basic Blue

Blue - Menetee PLA Blue

Red - Inland PLA+ True Red

Orange - Mika 3D PLA Orange

White - Overture Matte PLA White