____________________________________________________________________________________________________________________________________________________
☀️ If you want to sell prints of this model, as well as all of my models, future and past, become a member of my Patreon for a commercial license! ☀️
____________________________________________________________________________________________________________________________________________________


❄️Dive into a winter wonderland with our Snowflake Symphony bookmark set, where each delicate piece is a miniature masterpiece. Crafted for those who cherish the beauty of fine details, these bookmarks bring the enchantment of snowflakes to your favorite books. ❄️

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Jayo Black Transmission Distance: 0.3
PLA Prusa Gentleman's Grey Transmission Distance: 0.2
PLA KINGROON Blue Transmission Distance: 4
PLA+ Jayo Mint Green Transmission Distance: 4.5
PLA+ Jayo Sky Blue Transmission Distance: 4.4
PLA Jayo Matte White Transmission Distance: 4.6

Color Pallete:

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Gentleman's Grey
At layer #10 (0.88mm) swap to Blue
At layer #11 (0.96mm) swap to Mint Green
At layer #13 (1.12mm) swap to Sky Blue
At layer #15 (1.28mm) swap to White for the rest.

Want to buy me a coffee in show of support?☕Give me a boost or Paypal Me ❤️

If you like my work, drop me a follow!🤜🤛

______________________________________________________________________________________________________________________________________________________________

How to do more than 4 colors on a single AMS?

To use more than 4 colors with a single AMS is pretty simple when it comes to HueForges.

Always start the print from either Bambu Studio or Bambu Handy App - This will allow you to map the rolls of filaments to a certain slot in the AMS:

Now map the first 4 colors (which should already be inserted in the AMS to Slots 1 - 2 - 3 - 4
Once thats done move to maping colors 5 - 6 - 7 - 8 to respectively AMS Slots 1 - 2 - 3 - 4 again!

This will allow you to Change the rolls of filament once the printer is done with that color.
For example, in the picture above once we are done with the Black color (Which is usually first) we are going to remove the black roll (you can do that while printing) with White, then once Charcoal Black is done we are going to change that to Red, Dark Gray to Yellow and we are done. ~ You can do that with as many colors as you need!

If you like my work, drop me a follow!🤜🤛