I printed out the Modular storage system listed here → https://makerworld.com/en/models/489989#profileId-403310 by ChunkAhoy but didn't think the main box would hold up to being in the back of my work truck. Was not fond of the raw filament hinge or seal.

I found this box on printables, its also posted on Makerworld a million times.

As it's parametric I adjusted the vales in Fusion360 to fit the inserts made by ChunkAhoy. I also added a battery logo on the top and txt.

The name is customizable in Bambu Studio.

This box has a printable TPU seal which does a much better job than raw filament.

Requires 6x M3 x 30mm screws to finish

The latches will fit onto plate 2 if you wish and if you want them the same color as the box will not increase print time. If you want them a different colour (as to have “touch points”) then its best to leave them onplate 4 as total print time will be less.